vedardalarm"s Store > Fire Alarm System

Extinguishant Control Panel Gas Release fire fighting

Add to Cart
Conventional fire alarm fire automatic fighting system 4-zones Statusunit/Ancillary board connection Two wire RS485 connection with electronic fuse. Max. of 32 units-RS485 data cable.
4-zones conventional fire alarm fire automatic fighting system.
Extinguishant Control Panel CM1004
Shop professional fire alarm and security service equipment at
Technical specification
Mains supply 90 to 270VAC, 50Hz/60Hz
Mains supply fuse 3Amp ( F3AL250V) Replace only with similar type
Power supply rating 3Amps total including battery charge 28V +/- 2V
Maximum ripple voltage ≤200 millivolts
Battery type Two 12 Volt sealed lead acid in series. 7Ah maximum
Battery charge voltage 27.6VDC nominal
Battery charge current 0.7Amaximum
Current draw in mains fail condition 0.095Amps With buzzer sounding
Current draw in second stage alarm 0.235Amps Two zones in fire(470 ohm in circuit)
Current draw in post discharge condition 0.310Amps solenoid outputs active
Maximum current draw from batteries 3Amps With main power disconnected
NAC outputs(sounder & bell circuit) 26 to 28V DC Fused at 500mAwith electronic fuse 1.2Amp total load over all circuits
Fault relay contact rating 2A/30VDC maximum for each Volt free changeover contact
Fire relay contact rating 2A/30VDC maximum for each Volt free changeover contact
First stage contact rating 2A/30VDC maximum for each Volt free changeover contact
Second stage contact rating 2A/30VDC maximum for each Volt free changeover contact
Extract contact rating 2A/30VDC maximum for each Volt free changeover contact
Zone quiescent current 4mA maximum
Terminal capacity 0.5mm 2 to 2.5mm 2 solid or stranded wire
Number of detectors per zone ≤30 PCS conventional detectors
Number of sounders per circuit Dependent on type and current consumption
Detection circuit end of line 4K7±5% 1/2 Watt resistor 3K-5.6K 1/2W
Monitored input end of line 4K7±5% 1/2 Watt resistor 3K-5.6K 1/2W
Sounder circuit end of line 10K±5% 1/2 Watt resistor 6.8K-20K 1/2W
Extinguishant output end of line 10K±5% 1/2 Watt resistor 6.8K-20K 1/2W
No. of detection circuits Four 21 to 28V DC
No. of sounder circuits Four 21 to 28V DC
Extinguishant release output 21V to 28V DC. Maximum load 2Amp
Extinguishant release delay time Adjustable 0 to 75 seconds 5 second steps
SIL,AL, FLT, RST inputs Switched – min resistance 0 ohms, max 1k ohms
Detector alarm threshold 270 ohms to 1K ohms
Call point alarm threshold 150 ohms to 1K ohms
Short circuit threshold 0 ohms to 130 ohms
Statusunit/Ancillary board connection Two wire RS485 connection with electronic fuse. Max. of 32 units-RS485 data cable
Size 383mm W x 295mm H x 87mm D metal enclosure
Weight 5kg
    • UPC 704693094772
    • Brand TC fire alarm
    • Mfg Part # CM1004
Payment Methods
Shipping FEDEX, see description.
Payment Policy

Conditions of use

Hello and welcome to Vedard Alarm Systems Store. When you visit or shop at our alarm systems online store, you agree to these conditions.

Vedard Alarm Systems Company attempts to make product descriptions as accurate as possible. However, Vedard does not warrant that product descriptions are complete, current or error-free. If there is any doubts, please feel free to send email to check with us before buying.

Alarm Systems are devices of installation required before using. So, please make sure there is experienced alarm installer, electronic engineer, security service or experienced alarm user for the installation work after item is bought.

Vedard is not responsible for any wrong purchasing, non working of product with wrong configuration. Please make sure the wireless compatibility of buying wireless alarm accessories, wireless sensor with your exist wireless alarm system.

Cause of high rate international shipping charge for you and us, we do not accept fault goods return. But we offer 50% off new one sales for compensation. Product fault evidence is required.

You are welcome to post alarm systems reviews, comments on our website for your purchased products. And you are welcome to leave us a review at third party home security review website at home security reviews

Please make sure the content you posted is accurate, truthful and detailed to help visitors understanding our products and service well. has the right to monitor and edit or remove any activity or content.

Shipping Policy

Thanks for shopping alarm systems at Vedard Alarm Systems Store.

Preparation for delivery usually takes 3~7 business days.

Generally, DHL shipping service is used for delivery and delivery time is 3~5 business days for most countries.

For package weight less than 2kgs, we may use air post service for delivery and delivery time may be 15~25 days.

Once an order was shipped, you will receive an email with tracking information.

Low customs value will be made to reduce your import tax in our commercial invoice.

If you have special requirement for shipping, please leave comment with us when you place the order. Thank you!

We can send email of alarm system manual for your preparing installing new technology alarm systems. Please contact us to send the alarm system manual.

If your ordered goods is happened out of stock or not available to be shipped, we will issue 100% refund immediately and send email notice to you.

Tracking No. will be provided.

We may use DHL, EMS, China post air mail, Swiss post air mail to deliver your parcel.

The parcel tracking Website is as below:


China post air mail


Swiss post air mail

Return/Exchange Policy

Your benefit is guaranteed while shopping at Vedard Security Systems Store.

We will refund you product rate once product shipped is found with fault.

But video, photo evidence should be provided and confirmed by our technical department. Refund application should be submitted within 7 days after products received. Refund application should be sent to and title with Refund order #.

Buyers are requested to read and know product carefully before buying. And you can ask question via our forum or e-mail. We don't accept wrong buying refund.

Buyer can select to return to us with product rate and freight rate refund. But return cost is charged by buyer.

Other Policies

Household alarms should be as necessary as household appliances. But home alarms are special products.It plays an important role in keeping the family safe.Therefore, the installation and use of family alarm should be based on the home environment safety needs and alarm installation requirements. For wireless alarm, different manufacturers, different brands of alarm equipment is not compatible. Therefore, before buying an alarm, carefully read the product description and understand the brand of the product to determine its wireless compatibility.
There are many kinds of alarms. Alarm manufacturers designed a variety of alarms for different users of different habits or environmental differences. Therefore, you can choose the most appropriate alarm according to your own security needs.
Before buying alarm equipment, you should understand the functions and characteristics of all kinds of alarms and your own security needs. If you have any questions, please contact the product seller. Professional alarm equipment sales will provide detailed product installation instructions, video demonstrations, and technical guidance.
The products details and technical support for vedardalarm security can be found at

Please Login or Register first before asking a question.
More from vedardalarm's Store